CANDELA GENTLEMAX PRO INSTALL
CANDELA GENTLEMAX PRO PRO
CANDELA GENTLEMAX PRO VERIFICATION
CANDELA GENTLEMAX PRO FREE

CANDELA GENTLEMAX PRO FREE

If you are unsure about which component needs repair or replacement, you can send your machine to us for a free diagnosis. If you notice a significant decrease in power, this can mean that the laser flash lamp is no longer efficient or effective enough and needs to be replaced. A faulty power supply or capacitor can cause electrical imbalances in your machine, which can damage or burn the flash lamp. Excessive pressure or a leak in the laser head can also cause the flash lamp to stop working. It is important note that there can be absolutely no dust getting into these components, as dust can cause the laser head rod to burn, the flash lamp, flow tubes, and much more. If one of these components fails, it can cause the flash lamp to stop working. The lamp creates energy to a desired or predetermined setting and then fires that energy into the other components of the laser head, such as the rod, optics, making it small enough to enter the hand unit, and then finally onto the hand instrument through additional optics which adjust the size of the laser before it contacts the treatment area.

Candela Flash Lamp InformationĪ Candela flash lamp is generally found in the laser head of the aesthetic laser machine.

CANDELA GENTLEMAX PRO VERIFICATION

Perform an alignment verification for GL systems refer to Service Procedure 8503-Ġ1-0610 for GL PLUS, GL 18mm and GL LE refer to Service Procedure 8503-01-Ġ690 for MGL refer to Service Procedures -01-0826. GentleLASE Flashlamp Replacement Procedure Candela CorporationĨ. Refer to 80, 7121-99-ĩ390 or 98 drawing for specific details.

CANDELA GENTLEMAX PRO INSTALL

Install the Laser Head on the Monolithic Laser Rail. Of the lamps and fasten into place with screws.ħ. Clean and then carefully place the lamp o-ring retainer end cap plates over each end Make sure that the flashlamps are evenly positioned in the pump cavity.Ħ. Push the o-rings into the o-ring grooves. Install the flashlamps in the proper orientation per drawing 00. The flashlamp wires so that when the lamps are installed into the cavity channels, noĥ. Thoroughly clean the new flashlamps so that they are free of fingerprints. Remove the flashlamps from the laser head.Ĥ. Pay attention to component order when disassembling.ģ. Remove the two screws of each o-ring retainer end cap plate that secure theįlashlamps. These retainers are what hold the flashlamps in place. There are two lamp O-ring retainer end cap plates for each flashlamp located at eachĮnd of the laser head. Remove the Laser Head per the Laser Head Replacement Procedure. Lightly wipe with methanol, acetone, orġ. With filtered, compressed nitrogen or air. Need to be put down, lay them on clean piece of lens tissue over a piece of foamĪvoid the need to clean the optics other than by gently blowing the dust off of them Hold them over the bench, not over the floor. SomeĪdditional suggestions are: keep these components in their containers until they willīe installed into the assembly. Therefore, it is important to handle them carefully. The flashlamps are bothįragile and expensive. Must be worn when handling the GentleLASE flashlamps. The laser to operate for its maximum lifetime.

Refer toĪppropriate optic handling precautions and techniques must be followed in order for These flash lamps will fit the following Candela machines: This package will contain 2 flash lamps and 1 complete seal kit.

CANDELA GENTLEMAX PRO PRO

NEW flash lamps for the Candela GentleLase pro, GentleYAG pro, GentleMAX pro laser head, plus seal kit.

Candela gentlemax pro